SolidWorksMakroprogrammierung

Enumeration · SwConst

swExplodeDirectionIndex_e-Enumeration

In welche Achsrichtung des Manipulators ein Explosionsschritt die Komponenten oder Körper verschiebt: X, Y oder Z.

Bibliothek SwConst · 4 Werte · im Code direkt mit Namen verwendbar, zum Beispiel swExplodeDirectionIndex_Unknown

Syntax

Enum swExplodeDirectionIndex_e
    swExplodeDirectionIndex_Unknown = -1
    swExplodeDirectionIndex_XAxis   = 0
    swExplodeDirectionIndex_YAxis   = 1
    swExplodeDirectionIndex_ZAxis   = 2
End Enum

Werte

KonstanteWertBedeutung
swExplodeDirectionIndex_Unknown-1Nur für ExplodeStep.SetExplodeDirection: Die bisher eingestellte Richtung bleibt.
swExplodeDirectionIndex_XAxis0Verschieben entlang der X-Achse des Manipulators.
swExplodeDirectionIndex_YAxis1Verschieben entlang der Y-Achse des Manipulators.
swExplodeDirectionIndex_ZAxis2Verschieben entlang der Z-Achse des Manipulators.

Beispiel

' swConfig ist die aktive Konfiguration (Configuration) einer Baugruppe mit Explosionsansicht.
Dim swSchritt As SldWorks.ExplodeStep
Dim swRichtung As Object
Dim nAchse As Long
Set swSchritt = swConfig.GetExplodeStep(0)
Set swRichtung = swSchritt.GetExplodeDirection(nAchse)
Select Case nAchse
    Case swExplodeDirectionIndex_XAxis: Debug.Print "X-Achse"
    Case swExplodeDirectionIndex_YAxis: Debug.Print "Y-Achse"
    Case swExplodeDirectionIndex_ZAxis: Debug.Print "Z-Achse"
End Select
If Not swRichtung Is Nothing Then Debug.Print "Mit ausgewähltem Richtungselement"

Bemerkungen

Die Richtung übergibst du an Configuration.AddExplodeStep2 (Baugruppe) oder Configuration.AddPartExplodeStep (Mehrkörperteil) im Parameter ExplDirIndex. ExplodeStep.GetExplodeDirection und PartExplodeStep.GetExplodeDirection liefern sie zurück, ExplodeStep.SetExplodeDirection und PartExplodeStep.SetExplodeDirection ändern sie. Die ExplodeStep-Befehle gelten nur für normale Explosionsschritte, nicht für Schritte von Unterbaugruppen.

Zusätzlich zur Achse kann ein Schritt ein Richtungselement haben: eine zylindrische oder kegelige Fläche, eine gerade Kante oder eine Achse. Vor dem Anlegen wählst du es mit Markierung 2 aus. Du kannst Achse, Element, beides oder keins angeben. Fehlt beides, gilt die Z-Achse. Übergibst du beim Ändern ein gültiges Element, aber einen ungültigen Index, setzt SOLIDWORKS den Index auf die Z-Achse zurück. Ob swExplodeDirectionIndex_Unknown dabei als ungültig zählt, sagt die Hilfe nicht.

Die Hilfe beschreibt die drei Achsen nur mit ihrem Namen. Für den Drehring eines Explosionsschritts gibt es entsprechend swRotationAxisIndex_e.

Verwendet von

Siehe auch

Englisches Original: swExplodeDirectionIndex_e in der SOLIDWORKS API-Hilfe ↗

Fragen zu diesem Befehl oder ein Befehl fehlt? Frag im Discord.